kneeboard octafish art bonzer

Octa-Knees

Surfy Surfy By Surfy Surfy5 Comments





5’8″ Bonzer5 Octafish kneeboard custom shaped by Malcolm Campbell. Tuna shark artwork by George Spicer Bredehoft aka Kneeboard George.

George reports:

5’6.5″ x 23″ @ 0.625″ behind center. Nose back 12″ is 17.875″. Tail up 12″ is 19.7″. Pins are 12.125″. Without the eWings the pins would have been 15″. The inset of the eWings is .5″ at 10.75 up from the tail which is roughly equal with the trailing edge of the rear Bonzer fins. Max thickness is just shy of 2″ (glassed) at about the wide point. This measurement is without the 60″ long 3/8″ thick EVA deck pad.

5 Comments
Surfy Surfy

Posts by Surfy Surfy

previously

10

up next

You can ride this surfboard,

Leave a Comment

Your email address will not be published. Required fields are marked *

5 Comments
  • Anonymous
    November 8, 2010

    I just scored an original Malcolm Campbell(Malcolm’s signature next to the stringer also) Bonzer 6’6″ with original fin in the fin box and almost mint condition….and bonus, it still has the original Astrodeck tail pad on it….I’m stoked!!!! : )

    Reply
  • Anonymous
    November 8, 2010

    Just stand up. Its easy. Wait Greenough didn’t standup too much…never mind.

    Reply
  • dogleg
    July 25, 2011

    sorry for this but, dims?
    kneeboards are great for standing too.

    Reply
  • Surfy Surfy
    July 25, 2011

    The dims are unknown *sigh*

    Reply
  • JP St Pierre
    August 21, 2011

    George sez:
    5’6.5″ x 23″ @ 0.625″ behind center. Nose back 12″ is 17.875″. Tail up 12″ is 19.7″. Pins are 12.125″. Without the eWings the pins would have been 15″. The inset of the eWings is .5″ at 10.75 up from the tail which is roughly equal with the trailing edge of the rear Bonzer fins. Max thickness is just shy of 2″ (glassed) at about the wide point. This measurement is without the 60″ long 3/8″ thick EVA deck pad.

    Reply